|
Post by paulsminimad on Apr 5, 2011 18:32:50 GMT
hiya peeps does anybody know how to remove the bottom ball joints from the hub?? Thanks
|
|
|
Post by stumpy on Apr 5, 2011 19:29:20 GMT
The way to remove the balljoint is by using a spliter . you then peel back the locking washer and remove the grease nipple. Then you need a deep socket to undo the large top nut and you can then take shims out to tighten it up or repalce if worn out. Hope this helps.
DOCTOR DAVE
|
|
|
Post by muddymoke on Apr 5, 2011 20:31:39 GMT
Better to do it off the car and do both at same time! And if you don't have a spliter just give the suspension arm a good smack with a hammer should do the job!
|
|
|
Post by paulsminimad on Apr 5, 2011 20:36:58 GMT
what do that the top ones aswell? yeah i got a splitter mate just need to do these ones on the hub and then put it back together and its ready to drive ;D but not really sure where to start lol never done it before so dont really know what im doing lol
|
|
|
Post by muddymoke on Apr 6, 2011 12:26:47 GMT
Yes do top and bottom at same time! Start by jacking up car :-)
|
|
|
Post by paulsminimad on Apr 6, 2011 19:18:11 GMT
its already on axle stands mate ;D
|
|