|
Post by paulsminimad on Apr 2, 2011 18:27:57 GMT
Hiya peeps, how do you remove the lower ball joints off of the hub? i have bought new ones but i dont think they are right ones as they dont have a thread on them... any help with this would be great... Thanks
|
|
|
Post by stumpy on Apr 2, 2011 18:36:54 GMT
Can you put a picture of them on here so we can see
|
|
|
Post by paulsminimad on Apr 2, 2011 18:59:30 GMT
yeah no probs will go get them out the garage
|
|
|
Post by paulsminimad on Apr 2, 2011 19:39:51 GMT
here you go... hope this helps...
|
|
|
Post by terryg on Apr 2, 2011 20:02:30 GMT
|
|
|
Post by terryg on Apr 2, 2011 20:07:02 GMT
here you go... hope this helps... but that not a ball joints!! come to my garage to mo,s iv got the tool you need
|
|
|
Post by stumpy on Apr 2, 2011 20:14:56 GMT
What you have got there is a knuckle joint which fits between the top arm and the cone then this goes up into the subframe to the suspension doughnut. The way to remove the balljoint is by using a spliter . you then peel back the locking waher and remove the grease nipple. Then you need a deep socket to undo the large top nut and you can then take shims out to tighten it up or repalce if worn out. Hope this helps.
DOCTOR DAVE
|
|
|
Post by paulsminimad on Apr 3, 2011 7:48:10 GMT
Thanks guys I have already got a ball Joint Splitter mate coz i have split the bottom ball joints from the bottom arms and the track rod ends i just need to get the bottom ball joints off of the hub.....
|
|