|
Post by thelegg on Jun 25, 2012 20:59:19 GMT
i hope so too owell guess i could always pressure wash it off if it gets really dirty :L
|
|
|
Post by thelegg on Jul 5, 2012 23:21:30 GMT
Oil cooler plus fitting brackets and pipe work have arrived
|
|
|
Post by thelegg on Jul 9, 2012 22:17:11 GMT
ok so started striping old engine n car ready for the swap. Got the grill off and any other bits that were in the way, disconnected all the heater pipes/drained out the water Next started to take the brake servo out then off came the exhaust, disconnected the gear selector rods and drained out the oil then found out that with the fuel pipe off petrol was leaking everywhere so decided to siphon the tank n ended up with a mouthful of petrol :L should be cracking on tomorrow, plan to get the wheels off drive shafts out and then start to take the engine out
|
|
|
Post by thelegg on Jul 11, 2012 22:50:58 GMT
|
|
sacha
New Member
Posts: 7
|
Post by sacha on Jul 12, 2012 16:30:52 GMT
Mate nice engine hope it all goes well door cards are great thanks
|
|
|
Post by thelegg on Jul 12, 2012 23:00:42 GMT
|
|
|
Post by thelegg on Jul 14, 2012 23:17:15 GMT
|
|
|
Post by thelegg on Jul 16, 2012 23:47:56 GMT
Ive started the engine but Had a few problems, slight oil leak by the filter and the rubber grommet that the brake servo pipe goes into has split so i am unable to tune the engine at the moment as its leaking air n making it run really badly
|
|
|
Post by thelegg on Jul 30, 2012 21:45:59 GMT
|
|